|
|
||
 |
||
XBH offers Gold, Silver and ITO nanometal inks for inkjet printing applications. Particle sizes are typically between 3 to 7 nm,
and various types of metal % content, solvents and viscosities are available, as described in the matrix chart below.
| Product |
Au-Ink |
Ag-Ink |
Ag-Ink (Low Temperature) |
ITO-Ink | ||||||
| Type | Au1 | Au1T | Au2T | Au2a | Ag1 | Ag1T | Ag2 | L-Ag | L-Ag1 | ITO-Dn |
| For Ink Jet | N/A | Good | N/A | N/A | N/A | Good | N/A | N/A | Good | Good |
|
Metal Content (wt%) |
30 | 60~70 | 40 | 55~60 | 30 | 55~60 | 30 | 30 | 55~60 | 20 |
| Solvent | Toluene | n-tetradecane | Toluene | Tetradecane | Toluene | Tetradecane | Toluene | Toluene | Tetradecane | Decalin |
|
Adhesiveness Improving Additives |
-- | -- | Cu, Bi | Cu, Bi | -- | -- | Cu, Bi | -- | -- | -- |
|
Ave.particle size (nm) |
3~7 | |||||||||
|
Viscosity (mPa's) |
<5 | 5~15 | <5 | 4000~10000 | <5 | 5~15 | <5 | <5 | 5~15 | <5 |
Properties of curing
layer (Data provided
hereunder is for
reference only and not
guarantee)
| Curing Condition | 350°Cx30min or 300°Cx30min | 300°Cx30min | 220°Cx30min | 150°Cx60min | *1 | |||||
| Layer After Curing (µm) | <1 | <1 | <1 | <2 | <1 | <1 | <1 | <1 | <1 | <0.5 |
| Resistivity (µΩcm) |
8~10 (350°Cx30min) 12~15 (300°Cx30min) |
~ 20 | ~ 3 | ~ 3 | ~ 10 | 10 | 3x104 | |||
| Substrates to be used |
Substrates having allowable temperature
limit exceeding curing temperature should be used (e.g. glass, polyimide, Ni, Cu, ceramics etc) |
|||||||||
| Adhesion Strength (kg/mm2) | <1 | <1 | >2 | <1 | <1 | >2 | <1 | <1 | >2 | |
230°Cx10min in 8Pa Vac +
230°Cx60min in Air
Please consult us on the type not listed herein.
Specification in this sheet is subject to change without notice.
Highly Conductive Ink
Jet Printed Films of
Nanosilver Particles for
Printable Electronics
Inkjet-printed silver
tracks: low temperature
curing and thermal
stability investigation
Copyright and Disclaimerc © Xuan Bao Hao Corp. 隱私保護及安全聲明 | 智慧財產權 請使用IE 4.0以上版本之瀏覽器